2009 Hot Products Catalog

11 SEA DOO 4 STROKE INATKE SYSTEMS ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL SEA DOO RXP RXP-X RXT RXT-X • ENGINE RIVA SEA DOO VALVE TRAIN UPGRADE KIT Our Valve Train Upgrade Kit increases the reliability of your modified engine by reducing the possibility of valve float at high rpm. Includes lightweight, preci- sion-machined titanium valve retainers, racing valve springs, base washers and OE rocker arm shaft bolts that must be replaced during installation. Description Part No. Upgrade Kit, Valve Train, SD RXP/RXT/GTX RS19050-VTU VALVE COMPRESSION, TOOL SD 4-TEC Our overhead Valve Compression Tool allows easy removal of valve springs and keepers without removing cylinder head. Includes compression adapter to pressurize cylinder keeping valves in place during removal of stock springs and keepers. Description Part No. Tool, Valve Compression, SD 4-TEC RS19050-VCT RIVA RXP/RXT/GTX THERMOSTAT KIT Our cool running Thermostat Kit reduces the operating temperature of your modified 4-Tec ® engine by 30°F for maximum reliability and performance. Kit includes replacement thermostat, billet coolant inlet flange, stock thermostat removal tool, Oetiker ® clamps, Oetiker ® pliers and detailed installation instructions. *NOTE: Thermostat housing (shown above) not included. Description Part No. Thermostat Kit, SD RXP/RXT/GTX RS1015 RIVA SEA DOO PRO-SERIES ECU Our Pro-Series Racing ECU delivers a huge performance advantage to the Sea Doo 255 & 215 Supercharged Intercooled engines. ECU is calibrated for Stage II & III applications and must be used with RIVA Pro-Series 50lb Fuel Injector Kit, RIVA Valve Train Upgrade Kit and 91+ octane pump fuel. Plugs directly into factory wiring harness in place of stock ECU. Key benefits include: * Performance Fuel Mapping: Delivers optimal fuel required for your specific level of modification (Stage II or III) based on boost pressure. * Performance Timing Curves: Special racing curves produce more power throughout the RPM range. Timing is automatically adjusted based on sensor input. * Rev Limiter Increase: Stock rev limit has been increased from 8,300 to 8,650 RPM. With our recommended pump combination, engine RPM can be run higher producing more boost pressure and horsepower. * Practice Key: In addition to normal "full power" key, a 60 MPH "practice" key can be programmed by BRP dealer BUDS system to limit speed for race- course practice. ECU does not support original "learning" key mode. * Retains Engine Diagnostic & Primary Safety Functions: 1) Provides diagnostic information displayed on dash instrumentation along with more detailed data through BRP dealer B.U.D.S. system. 2) Sensor input is monitored for abnormal readings and will react by trigger- ing warnings and/or limp mode. *NOTE: This product is for competition use only. Must be used with RIVA Pro-Series 50lb Fuel Injector Kit (part #RS12050-I-KIT-50 • page 3), RIVA Valve Train Upgrade Kit and 91+ octane pump fuel. Unit must be activated in watercraft by an authorized BRP dealer using BUDS system. Activation by RIVA Racing available with customer supplied throttle body. Installation of this racing product will void BRP factory warranty. Description Part No. ECU, Pro-Series, SD 04-05 RXP/RXT RS11850-01-A ECU, Pro-Series, SD 06 RXP/RXT RS11850-01-B ECU, Pro-Series, SD RS11850-01-C 08 255 RXP-X/RXT-X, 07-08 215 RXP/RXT Injector Kit, Pro-Series, 50lb, SD 255/215 RS12050-I-KIT-50 Valve Train Upgrade Kit SD 4-TEC all RS19050-VTU