2011 Hot Products Catalog

YAMAHA GP 1300R EXHAUST POWER SLEEVE The R&D GP 1300R Exhaust Power Sleeve will add a serious boost to low end and mid range horsepower and performance! The R&D Exhaust Power Sleeve installs between the exhaust chamber and the catalytic housing to increase sonic wave energy! The R&D Exhaust power Sleeve will add the Y.P.V.S. (power valve) feel to the 2005 Yamaha’s non-power valve engine! Description Part No. Yamaha GP 1300R Exhaust Power Sleeve 332-13001 128 INTAKE SYSTEMS FOUR STROKE ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL Description Part No. Cat Temp Sensor Chip RY115-20 Yamaha 1200/1300 Powervalve (66V/66T) RIVA Cat Temp Sensor Chip is a must when removing the OEM catalytic converter on Yamaha 1200 & 1300 Powervalve engines. The circuit is designed to mimic the signal sent to the OEM CDI by the catalytic converter’s temperature probe preventing CDI, flutters, warning devices and engine shut downs due to cat removal. Can be used with stock or modified OEM CDI’s. Plugs directly into factory wire harness. RIVA CAT TEMP SENSOR CHIP FOR YAMAHA GPR 1200 & 1300 Part No. YE-155P Description JetWorks Catalytic Converter Removal Plate R&D D-PLATE FOR YAMAHA GP1200R/GP1300R, XLL/XLT1200 The new R&D D-Plate takes the place of the stock catalytic converter and delivers the best overall low, mid, peek and overall horsepower. The benefits include reducing engine compartment temperatures created by the catalytic converter and reliability of the complete stock exhaust assembly. Part No. 332-12000 Description R&D D-Plate CATALYTIC CONVERTER REMOVAL PLATE FOR YAMAHA GP1200R/GP13OOR, XLL/XLT1200 This plate allows you to remove the catalytic converter easily and fills the gap where the catalytic converter mounts on the OEM exhaust system. Benefits include a cooler running exhaust system and ability to run any kinds of two-stroke oil. The plate features a centrally located outlet designed to give some beneficial back pressure but with much better exhaust gas flow compared to an offset or cutout plate. This gives better response and acceleration throughout the power band. FOR COMPETITION USE ONLY . R&D BILLET EXHAUST VALVES FOR GPR The new R&D Billet Exhaust Valves reduce the clearance between the valve and piston. this reduced clearance improves the seal which boosts the valve down compressions ratio delivering greater bottom and mid-range power. Directly replace OEM YPVS valve units. Part No. 332-12002 332-12003 332-13000 Yamaha GP800/GP1200R Exhaust Valve Kit (each) Exhaust Valve Arm Only GP1300R Exhaust Valve Kit (each) 332-12003 332-12002 Part No. 010-495-10 010-495-05 Sea Doo OEM No. A. Exhaust Valve Piston 420-854-449 B. Exhaust Valve Bellow 290-260-723 A . B . REPLACEMENT EXHAUST VALVE PARTS FOR SEA DOO R&D KAWASAKI 800 SXR EXHAUST POWER SLEEVE The new R&D billet aluminum Exhaust power Sleeve is designed to insert into the stinger of the stock exhaust to reduce the stinger size thereby increasing back pressure. This is a simple installation that will increase top speed and add 100 RPM. Description Part No. Kawasaki 800 SXR 331-80000