2011 Hot Products Catalog

158 INTAKE SYSTEMS FOUR STROKE ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL Description MSD Timing Light Part No. 8990 MSD TIMING LIGHT MSD offers a heavy duty top quality timing light. This timing light is supplied in a heavy duty metal housing and features a high output Linear Xenon strobe with a focused fresnel lens that produces a light that’s bright enough to use outdoors. It is equipped with a 6 foot lead and uses a metal inductive pickup that clamps to the spark plug wire. Description MSD External Starter Relay Part No. M4390 MSD EXTERNAL STARTER RELAY This 12 volt relay is a heavy duty unit designed to mount outside the electrical box. It’s made with material that locks out moisture and chemicals. The large copper terminals assure good solid contact with your wiring. The stainless steel base plate allows the relay to be mounted in any position. Rated at 65 amps. Description Kawasaki 750 SX/SXI/95ZXI Part No. 4251 YAMAHA 650/701 ENHANCER 4253 ENHANCER IGNITIONS SEA-DOO 800 ENHANCER At lower rpm you’ll notice incredible acceleration and throttle response due to advancing the timing. Then as the rpm increases, the timing is retarded to the factory setting to prevent detonation and engine damage. for racers, there is also a lower rpm limit that you can activate for quick and consistent holeshots. By activating a switch (Part# 4372 see page 144) mounted on the handle bar the rpm will limit at approximately 3,000 rpm. The instant the but- ton is released, the rpm revs up just as normal and you rocket off. Everything you need to install the Yamaha Enhancer is supplied along with factory connectors for a direct plug-in installation! Not compatible with Yamaha 760 engine applications. Description Yamaha 650/701 Part No. 4253 Description Sea Doo 800 ‘95-96, 97-98 SPX, GTX KAWASAKI 750 ENHANCER The Kawasaki 750 Enhancer features the increased spark energy you expect from MSD plus they have an adjustable rev limiter and holeshot rpm limit. The rev limit is adjusted with a potential on the back of the ignition housing. The holeshot feature lets you activate a lower rpm limit that is best to use for quick starts at the beginning of a race. Also, these ignitions can be connected to the factory overheat sensor. With this feature, if the water tem- perature gets too high, the Enhancer will limit the rpm to a safe value to avoid any engine damage. Note: Enhancer will not work on 1996Zxi. 4251 The Enhance Ignition for the Sea Doo ® 800 (also the ‘95, ‘96, XP and GSX) uses a high speed RISC microprocessor to control all of the timer and rev limiter functions. This opens the door for programming, giving you the ability to set two rev limits and a timing curve through a series of dip switches built into the Enhancer. Being able to control the ignition curve lets you match the timing specifically to your engine and its modifications. The Digital Enhancer produces a series of sparks through 3,000 rpm rather than just a single spark. This feature delivers incredible throttle response, acceleration and keeps the idle clean and smooth. Note: This modification will eliminate the factory DSS security system and the handlebar kill feature. Part No. 4255 Each Enhancer is a direct plug in unit and is designed to fit in the stock location. The Enhancer Ignition gives the racer an edge due to the powerful spark energy and adjustable rev-limiter. The Enhancer Ignitions produce a much more powerful spark, as much as four times more spark energy, to insure complete combustion of the fuel mixture. This complete combustion results in improved performance including quick throttle response, improved pulling power and top end, plus will reduce spark plug fouling. Whether your watercraft is stock or if you’ve added other modifications such as a better flowing intake or exhaust modifications, the Enhance ignitions will improve the performance.