2015 Hot Products Catalog

219 FOUR STROKE INTAKE SYSTEMS ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL ©2015 Hot Products. All rights reserved. 4253 MSD YAMAHA 650/701 ENHANCER At lower rpm you’ll notice incredible acceleration and throttle response due to advancing the timing. Then as the rpm increases, the timing is retarded to the factory setting to prevent detonation and engine damage. For racers, there is also a lower rpm limit that you can activate for quick and consistent holeshots. Everything you need to install the Yamaha Enhancer is supplied along with factory connectors for a direct plug-in installation! Not compatible withYamaha 760 engine applications. Description Part No. Yamaha 650/701 4253 MSD KAWASAKI 750 ENHANCER The Kawasaki 750 Enhancer features the increased spark energy you expect from MSD plus they have an adjustable rev limiter and holeshot rpm limit. The rev limit is adjusted with a potential on the back of the ignition housing. The holeshot feature lets you activate a lower rpm limit that is best to use for quick starts at the beginning of a race. Also, these ignitions can be connected to the factory overheat sensor. With this feature, if the water temperature gets too high, the Enhancer will limit the rpm to a safe value to avoid any engine damage. Note: Enhancer will not work on 1996 ZXi. Description Part No. Kawasaki 750 SX/SXI/95ZXI 4251 4251 MSD SEA-DOO 800 ENHANCER The Enhancer Ignition for the Sea-Doo ® 800 (also the ‘95, ‘96, XP and GSX) uses a high speed RISC microprocessor to control all of the timer and rev limiter functions. This opens the door for programming, giving you the ability to set two rev limits and a timing curve through a series of dip switches built into the Enhancer. Being able to control the ignition curve lets you match the timing specifically to your engine and its modifications. The Digital Enhancer pro- duces a series of sparks through 3,000 rpm rather than just a single spark. This feature delivers incredible throttle response, acceleration and keeps the idle clean and smooth. Note: This modification will eliminate the factory DSS security system and the handlebar kill feature. Description Part No. Sea-Doo 800 ‘95-96, 97-98 SPX, GTX 4255 ENHANCER IGNITIONS Each Enhancer is a direct plug in unit and is designed to fit in the stock location. The Enhancer Ignition gives the racer an edge due to the powerful spark energy and adjustable rev-limiter. The Enhancer Ignitions produce a much more powerful spark, as much as four times more spark energy, to insure complete combustion of the fuel mixture. This complete combustion results in improved performance including quick throttle response, improved pulling power and top end, plus will reduce spark plug fouling. Whether your watercraft is stock or if you’ve added other modifications such as a better flowing intake or exhaust modifications, the Enhance ignitions will improve the performance. MSD STOCK IMPROVED COIL Replace your old factory coil with this direct bolt-on. • Replaces Stock kawasaki & Yamaha Coils • Molded -In 8.5mm Super Conductor Wires • Output Voltage - 30KV • Primary Resistance - .08 OHM • Secondary Resistance - 2K OHMS • Used with Enhancer Ignition for Yamaha 650/701 and Kawasaki 750 only Description Part No. Stock Improved Coil for Start-Up 4294 IGNI-PRO PROGRAMMABLE IGNITION The best is now even better! The all new updated Igni Power ignition does not require battery power like previous Igni Power ignitions or OEM Kawasaki CDI’s when the engine is not running, thus eliminating the bat- tery draw down issue of the past. Igni Pro is a high power ignition which is fully programmable with any computer or laptop. Simple and easy to connection via a USB cable. This allow you to program your ignition to your specific engine modifications and any future changes to your engine package. This ignition upgrade will increase power with any modification even you utilize the OEM stock pipe. The ignition can be operated as a total loss system with a TBM total loss flywheel. This system fits perfectly in the OEM ignition box for reliability. Supplied with complete instructions and programming software (all Windows except Vista). Description Part No. Igni-Pro Programmable Ignition 800 SX-R IGNI800SXR 4255