2015 Hot Products Catalog

9 SEA-DOO 4 STROKE INATKE SYSTEMS ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL ©2015 Hot Products. All rights reserved. SEA-DOO 4-STROKE • SUPERCHARGER R&D SUPERCHARGER SLEEVE The sleeving up of the diameter of the Supercharger enables a 3.5" or 4" intake filter system to be utilized. The larger intake increases cubic air volume as well as decreases air inlet restriction. A win win, supercharge your supercharger and give it more air! Available in 3.5" and 4" diameters. Fits all Supercharged 4-Tec Models. Description Part No. R&D Supercharger Sleeve 3-1/2" Diameter 613-95035 R&D Supercharger Sleeve 4" Diameter 613-95040 ET 137X4MM CR DROP IN WHEEL FOR 255/260 ET Light Edition Billet Impeller with 4mm spacer. Aftermarket pressure regulator (not included) is required for this modification. 48Lbs injectors are required for this modification (not included). *Some Sea- Doo 255/260 model come with 48lb injectors from the factory, please check your OEM specifications before installing this upgrade. 13 to 13.5Lbs of boost@8100rpm and 15Lbs boost@8500rpm (Clutch slip must be set to 15 Lbs) Description Part No. 15 Lbs Boost Supercharger ET137X4MM CR Billet Impeller with 4mm spacer ET68-140 Complete Sea-Doo Xtreme Supercharger by ET. 16-16.5Lbs @8600rpm and 18Lbs@9000rpm Description Part No. ET68-140 Complete Supercharger ET68-140 ET70-145RACE Complete Sea-Doo Xtreme Supercharger by ET. This charger is capable of making up to 20Lbs of boost. This upgrade will require various upgrades: ECU, Injectors, Pressure Regula- tor and more depending on your engine configuration This ET supercharger requires “RACE FUEL” and is intented for racing. Description Part No. ET70-145 Race Edition Charger ET70-145RACE ET WATER COOLER FOR 255/260 WITH 4 POSTS ET’s new, innovative, fully Billet O-ringed water cooler cover.The back side of ET Water Cooler is CNC machined to the contour of the OEM housing using surfacing and features o-ring seals. Made from 6061-T6 Alum. and anodized black for cor- rosion resistance. Safely used with all OEM and ET Chargers, ET uses a 7mm spacer to ensure that the casting is thick and strong. It’s easy to install on the OEM Front housing without any modifications . Comes with bolts, fittings and o-rings. Testing results were that housing temperature dropped by 45 degrees in a 20Lb setup. Less boost fade. Improve bearing and seal life also less under hood heat. Description Part No. ET Water Cooler for ET-WC-COVER Sea-Doo 255/260 RIVA R ACING ’ S VENDOR BOOTH AT THE 2014 IJSBA J ETTRIBE W ORLD F INALS IN L AKE H AVASU C ITY , A RIZONA , USA.