9
SEA-DOO
4 STROKE
INATKE
SYSTEMS
ENGINE/
GASKETS
EXHAUST DRIVE LINE
HANDLING
ELECTRICAL WATERLINE
/BILGE
STEERING
& CONTROLS
BODY
ACCESSORIES
SERVICE TOOLS
/HARDWARE
CHEMICAL
©2015 Hot Products. All rights reserved.
SEA-DOO 4-STROKE • SUPERCHARGER
R&D SUPERCHARGER SLEEVE
The sleeving up of the diameter of the Supercharger enables a 3.5" or 4"
intake filter system to be utilized. The larger intake increases cubic air
volume as well as decreases air inlet restriction. A win win, supercharge
your supercharger and give it more air! Available in 3.5" and 4" diameters.
Fits all Supercharged 4-Tec Models.
Description Part No.
R&D Supercharger Sleeve 3-1/2" Diameter
613-95035
R&D Supercharger Sleeve 4" Diameter
613-95040
ET 137X4MM CR DROP IN WHEEL FOR 255/260
ET Light Edition Billet Impeller with 4mm spacer.
Aftermarket pressure regulator (not included) is required for this modification.
48Lbs injectors are required for this modification (not included). *Some Sea-
Doo 255/260 model come with 48lb injectors from the factory, please check
your OEM specifications before installing this upgrade.
13 to 13.5Lbs of boost@8100rpm and 15Lbs boost@8500rpm
(Clutch slip must be set to 15 Lbs)
Description Part No.
15 Lbs Boost Supercharger
ET137X4MM CR
Billet Impeller with 4mm spacer
ET68-140
Complete Sea-Doo Xtreme Supercharger by ET.
16-16.5Lbs @8600rpm and 18Lbs@9000rpm
Description Part No.
ET68-140 Complete Supercharger
ET68-140
ET70-145RACE
Complete Sea-Doo Xtreme Supercharger by ET.
This charger is capable of making up to 20Lbs of boost.
This upgrade will require various upgrades: ECU, Injectors, Pressure Regula-
tor and more depending on your engine configuration
This ET supercharger requires “RACE FUEL” and is intented for racing.
Description Part No.
ET70-145 Race Edition Charger
ET70-145RACE
ET WATER COOLER FOR 255/260 WITH 4 POSTS
ET’s new, innovative, fully Billet O-ringed water cooler cover.The back side of ET
Water Cooler is CNC machined to the contour of the OEM housing using surfacing
and features o-ring seals. Made from 6061-T6 Alum. and anodized black for cor-
rosion resistance. Safely used with all OEM and ET Chargers, ET uses a 7mm
spacer to ensure that the casting is thick and strong. It’s easy to install on the OEM
Front housing without any modifications . Comes with bolts, fittings and o-rings.
Testing results were that housing temperature dropped by 45 degrees in a 20Lb
setup. Less boost fade. Improve bearing and seal life also less under hood heat.
Description Part No.
ET Water Cooler for
ET-WC-COVER
Sea-Doo 255/260
RIVA R
ACING
’
S
VENDOR BOOTH AT
THE
2014 IJSBA
J
ETTRIBE
W
ORLD
F
INALS IN
L
AKE
H
AVASU
C
ITY
,
A
RIZONA
, USA.
