2016 Hot Products Catalog

219 FOUR STROKE INTAKE SYSTEMS ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE CHEMICAL ©2016 Hot Products. All rights reserved. HotProductsUSA.com • Orders & Info: 858-453-4454 4253 MSD YAMAHA 650/701 ENHANCER At lower rpm you’ll notice incredible acceleration and throttle response due to advancing the timing. Then as the rpm increases, the timing is retarded to the factory setting to prevent detonation and engine damage. For racers, there is also a lower rpm limit that you can activate for quick and consistent holeshots. Everything you need to install the Yamaha Enhancer is supplied along with factory connectors for a direct plug-in installation! Not compatible withYamaha 760 engine applications. Description Part No. Yamaha 650/701 4253 MSD SEA-DOO 800 ENHANCER The Enhancer Ignition for the Sea-Doo ® 800 (also the ‘95, ‘96, XP and GSX) uses a high speed RISC microprocessor to control all of the timer and rev limiter functions. This opens the door for programming, giving you the ability to set two rev limits and a timing curve through a series of dip switches built into the Enhancer. Being able to control the ignition curve lets you match the timing specifically to your engine and its modifications. The Digital Enhancer pro- duces a series of sparks through 3,000 rpm rather than just a single spark. This feature delivers incredible throttle response, acceleration and keeps the idle clean and smooth. Note: This modification will eliminate the factory DSS security system and the handlebar kill feature. Description Part No. Sea-Doo 800 ‘95-96, 97-98 SPX, GTX 4255 MSD STOCK IMPROVED COIL Replace your old factory coil with this direct bolt-on. • Replaces Stock kawasaki & Yamaha Coils • Molded -In 8.5mm Super Conductor Wires • Output Voltage - 30KV • Primary Resistance - .08 OHM • Secondary Resistance - 2K OHMS • Used with Enhancer Ignition for Yamaha 650/701 and Kawasaki 750 only Description Part No. Stock Improved Coil for Start-Up 4294 4255 THRUST INNOVATIONS MSD START/STOP MODULE The Thrust Innovations module terminates the need for a toggle switch to power off your MSD Total Loss Ignition. Easy to install instructions with picture diagram included. Waterproof module that will allow your OEM start/stop switch to function just like it was meant to, while running Total Loss, without the need for an additional switch. • Starts just like OEM (only when lanyard is attached) • Kills motor and powers down Total Loss once lanyard is removed or “STOP” button is touched momentarily • Does not draw from battery, will not cause battery drain • Sealed and potted to ensure water resistance and to isolate from shock • All connections are soldered • Comes with OEM connections to attach directly to your start/stop switch Description Part No. Total Loss Ignition Start/Stop Module TI-MSD-TL-MD MSD KAWASAKI 750 ENHANCER The Kawasaki 750 Enhancer features the increased spark energy you expect from MSD plus they have an adjustable rev limiter and holeshot rpm limit. The rev limit is adjusted with a potential on the back of the ignition housing. The holeshot feature lets you activate a lower rpm limit that is best to use for quick starts at the beginning of a race. Also, these ignitions can be connected to the factory overheat sensor. With this feature, if the water temperature gets too high, the Enhancer will limit the rpm to a safe value to avoid any engine damage. Note: Enhancer will not work on 1996 ZXi. Description Part No. Kawasaki 750 SX/SXI/95ZXI 4251 4251