Hot Products 2020 Catlog

233 © 2020 Hot Products. All rights reserved. FOUR STROKE INTAKE SYSTEMS ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE INDEX HotProductsUSA.com • Orders & Info: 858-453-4454 4253 MSD YAMAHA 650/701 ENHANCER At lower rpm you’ll notice incredible acceleration and throttle response due to advancing the timing. Then as the rpm increases, the timing is retarded to the factory setting to prevent detonation and engine damage. For racers, there is also a lower rpm limit that you can activate for quick and consistent holeshots. Everything you need to install the Yamaha Enhancer is supplied along with factory connectors for a direct plug-in installation! Not compatible withYamaha 760 engine applications. Description Part No. Yamaha 650/701 4253 MSD SEA-DOO 800 ENHANCER The Enhancer Ignition for the Sea-Doo ® 800 (also the ‘95, ‘96, XP and GSX) uses a high speed RISC microprocessor to control all of the timer and rev limiter functions. This opens the door for programming, giving you the ability to set two rev limits and a timing curve through a series of dip switches built into the Enhancer. Being able to control the ignition curve lets you match the timing specifically to your engine and its modifications. The Digital Enhancer pro- duces a series of sparks through 3,000 rpm rather than just a single spark. This feature delivers incredible throttle response, acceleration and keeps the idle clean and smooth. Note: This modification will eliminate the factory DSS security system and the handlebar kill feature. Description Part No. Sea-Doo 800 ‘95-96, 97-98 SPX, GTX 4255 MSD STOCK IMPROVED COIL Replace your old factory coil with this direct bolt-on. • Replaces Stock Kawasaki & Yamaha Coils • Molded -In 8.5mm Super Conductor Wires • Output Voltage - 30KV • Primary Resistance - .08 OHM • Secondary Resistance - 2K OHMS • Used with Enhancer Ignition for Yamaha 650/701 and Kawasaki 750 only Description Part No. MSD Stock Improved Coil 4294 4255 THRUST INNOVATIONS MSD START/STOP MODULE The Thrust Innovations module terminates the need for a toggle switch to power off your MSD Total Loss Ignition. Easy to install instructions with picture diagram included. Waterproof module that will allow your OEM start/stop switch to function just like it was meant to, while running Total Loss, without the need for an additional switch. • Starts just like OEM (only when lanyard is attached) • Kills motor and powers down Total Loss once lanyard is removed or “STOP” button is touched momentarily • Does not draw from battery, will not cause battery drain • Sealed and potted to ensure water resistance and to isolate from shock • All connections are soldered • Comes with OEM connections to attach directly to your start/stop switch Description Part No. Total Loss Ignition Start/Stop Module TI-MSD-TL-MD BATTERY PORTABLE CHARGERS The Guest automatic 3 stage portable battery charger is designed for fast charging and maintenance of 12v batteries. A durable case makes the charger waterproof, shockproof and corrosion proof. LED indicators, as well as electronic overload, polarity and thermal protection keep batteries safe and insure that they will never be overcharged. The charger features 6' AC cord and 4' DC output wire with alligator clips. Requires an input voltage of 100-130v AC/50-60Hz. Description Part No. A. Portable Battery Charger - 12 volt, 6 amps CU2606A B. Portable Battery Charger - 12 volt, 10 amps CU2612A A. B.

RkJQdWJsaXNoZXIy NjEwMDM=