Hot Products 2020 Catlog

MSD MINI STRIPPER-CRIMPER Designed to be in a vise and with a single- edge razor blade to strip spark plug wires without damaging the core and to crimp a terminal. Inexpensive too! Description Part No. Mini Stripper-Crimper 3503 234 © 2020 Hot Products. All rights reserved. INTAKE SYSTEMS FOUR STROKE ENGINE/ GASKETS EXHAUST DRIVE LINE HANDLING ELECTRICAL WATERLINE /BILGE STEERING & CONTROLS BODY ACCESSORIES SERVICE TOOLS /HARDWARE INDEX Orders & Info: 858-453-4454 • HotProductsUSA.com MSD EXTERNAL STARTER RELAY This 12 volt relay is a heavy duty unit designed to mount outside the electrical box. It’s made with material that locks out moisture and chemicals. The large copper terminals assure good solid contact with your wiring. The stainless steel base plate allows the relay to be mounted in any position. Rated at 65 amps. Description Part No. MSD External Starter Relay M4390 MSD SPARK PLUG BOOT RETAINERS There’s no excuse for losing a race due to a plug wire popping off when you run MSD’s Boot Retainers. These handy clamps are molded from heat resistant nylon material and will lock the boot to the spark plug. Description Part No. Boot Retainer, 90 o Spark Plug Boots & Terminal (2 cyl.) 3340 Boot Retainer, individual piece 15991 MSD SPARK PLUG BOOT & TERMINALS Description Part No. A. MSD 90 o Spark Plug Boots & Terminal (2 cyl.) 3311 A. MSD 90 o Spark Plug Boots & Terminal (3 cyl.) 3311-3 B. MSD Spark Plug Terminals (Pack of 100) 34615 B. MSD Spark Plug Terminals (Pack of 10) 34615-10 A. B. MSD 8.5MM SUPER CONDUCTOR SPARK PLUG WIRE Spark plug wires have two main objectives; transfer the spark energy and sup- press the Electro Magnetic interference (EMI) that the spark voltage creates. The MSD 8.5mm Super conductor delivers the best of both worlds. MSD uses a special copper conductor keeping resistance under 50 ohms per foot! Even with this low resistance, the wire retains high EMI suppression capabilities. By wrapping the conductor tightly around a ferro-magnetic impregnated center core and EMI choke is created, keeping any interference inside the wire. Length of each wire is 30” Description Part No. Two Cylinder Wire Set 31009 One Cylinder Wire Set 31019 Three Cylinder Wire Set 31039 Bulk Wire 25 feet - Red 34019 Bulk Wire 25 feet - Black 34013 Bulk Wire 100 feet - Red 34049 Bulk Wire 100 feet - Black 34043 Bulk Wire 300 feet - Red 34059 Bulk Wire 300 feet - Black 34053 31009 Bulk Wire MSD DUAL WIRE SEPARATORS These handy separators will secure two wires and keep them away from the exhaust or moving parts. Each wire can be moved easily and clipped right back in! Sold in a pack of 16. Description Part No. Dual Wire Separator (pack of 16) 8841 WATCON WATERPROOF RELAY This is a direct replacement for the Polaris watercraft & Weber / HSR starter relay. No modifications are required. It also works excellent in all “total loss” ignition systems or anything requiring a durable 12V starter relay. This waterproof start relay might save you some troubleshooting, especially in an extremely wet or salt-water envi- ronment. Used with SRPT-1 wiring connector. Description Part No. Watcon Waterproof Relay WP-R1 Watcon Wiring Connector SRPT-1